Datalogic-scanning C-BOX 200 Manual do Utilizador descarregar pdf (Página 8)

GUIDE TO INSTALLATION

The following can be used as a checklist to verify all of the steps necessary for

complete installation of the C-BOX 200.

1) Read all information in the section "Safety Precautions" at the beginning of this

manual.

2) Correctly position and mount the C-BOX 200 within the reach of the barcode

scanner cable, according to the information in paragraph 2.3.

3) Make all electrical connections according to your application. See par. 2.4.

4) Set all the proper configuration jumpers and switches according to your

application. See all sub-paragraphs under 2.4.

5) Connect the scanner to the C-BOX 200.

6) Switch-on the system.

7) Wait until the Warning Led (WL, red) is switched off.

8) Through the internal 9-pin male connector, (it carries the Scanner Aux. Serial Port

signals), configure the scanner according to your specific application using the

WinHost™ software configuration tool.

9) Perform the 'Get Scanner Configuration' procedure using the internal keys (see

paragraph 2.7.1).

10) Wait until the Warning Led (WL, red) is switched Off.

Now the C-BOX 200 contains the scanner configuration.

The installation is complete.

viii

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sem comentários

Datalogic-scanning C-BOX 200 Manual do Utilizador Página 8