Datalogic-scanning C-BOX 200 Manual do Utilizador descarregar pdf (Página 17)

INSTALLATION

The C-BOX 200 spring clamp connector pinouts are indicated in the following table.

Refer to the scanner Installation Manual for details.

Pin Name

1, 3, 5 VS

2, 4, 6 GND

7, 8 EARTH GROUND

*9, 13 RS485 CABLE SHIELD

*10, 14 RS485 REF

*11, 15 RTX485+

*12, 16 RTX485-

20, 33, 34, 40 Reserved

21 OUT1+

23 OUT2+

27 EXT TRIG+

28 EXT TRIG-

35 TXA

37 RXA

39 SGND

DS2100A

DS2400A

DS4600A

22 OUT REF OUT1-

24 OUT REF OUT2-

25, 26 NC Reserved

29 NC IN1+

30 NC IN1-

31 NC IN2+

32 NC IN2-

36 RTSA GND

38 CTSA SGND AUX

• The signals on pins 9, 10, 11 and 12 are repeated on pins 13, 14, 15 and 16 to facilitate network

connections (i.e. Multiplexer connections using the RS485 half-duplex Interface). In this way the

network bus can enter and exit the C-Box 200 from different spring clamps but be physically connected

together.

NOTE

Pin 7 or 8 should be connected to the earth ground.

Pin 17, 18 and 19 are not present in the C-BOX 200 model.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Sem comentários

Datalogic-scanning C-BOX 200 Manual do Utilizador Página 17