Datalogic-scanning Matrix 400 Manual do Utilizador descarregar pdf (Página 20)

MATRIX 400™ REFERENCE MANUAL

Learn

8. Enter the Learn function by pressing and holding

the X-PRESS™ push button until the Learn LED is

on.

9. Release the button to enter the Learn function.

The Learn LED will blink until the procedure is

completed.

The Learn procedure ends when the Image

Processing and Decoding parameters are

successfully saved in the reader memory, the

Learn LED will remain on continuously, the Green

Spot is activated and Matrix 400™ emits 3 high

pitched beeps.

If the calibration cannot be reached after a timeout

of about 3 (three) minutes Matrix 400™ will exit

without saving the parameters to memory, the

Learn LED will not

remain on continuously but it will

just stop blinking. In this case Matrix 400™ emits a

long low pitched beep.

10. Exit the Setup function by pressing the X-

PRESS™ push button once.

READY

green

ellow

red

SETUP

FOCUS

LEARN

GOOD

RIGGER

COM

STATUS

Figure 14 – X-PRESS™ Interface:

Learn Function

If you have used this procedure to configure Matrix 400™ go to step 9.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 141 142

Sem comentários

Datalogic-scanning Matrix 400 Manual do Utilizador Página 20