Datalogic-scanning POWERSCAN 7000 Manual do Utilizador descarregar pdf (Página 159)

Trigger Commands

Product Reference Guide 10-5

This response indicates that the device’s Codabar Coding Enable

(CBRENA) is set to 1, or on;

the Start/Stop Character (SSX) is set to 0, or Don’t Transmit;

the Check Character (CK2) is set to 0, or Not Required;

concatenation (CCT) is set to 1, or Enabled;

the Minimum Message Length (MIN) is set to 2 characters;

the Maximum Message Length (MAX) is set to 60 characters;

and the Default setting (DFT) has no value.

Trigger Commands

You can activate and deactivate the imager with serial trigger commands.

First, the imager must be put in Manual/Serial Trigger Mode either by

scanning the Manual/Serial Trigger Mode bar code (

page 3-5), or by

sending the Manual/Serial Menu Command (

page 10-10). Once the

imager is in serial trigger mode, the trigger is activated and deactivated

by sending the following commands:

Activate:

SYN T CR

Deactivate: SYN U CR

The imager scans until a bar code has been read, until the deactivate

command is sent, or until the serial time-out has been reached (see

Read

Time-Out on page 3-5

for a description) and the serial command on

page 10-10).

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 203 204

Sem comentários

Datalogic-scanning POWERSCAN 7000 Manual do Utilizador Página 159