Datalogic-scanning PDA Manual do Utilizador descarregar pdf (Página 20)

Getting Started

8 Falcon

Management Utility (FMU)

Setting Up FMU

Depending on the type of install you selected (Server Install, Workstation

Install, or Complete System), the process for setup will vary.

Complete System

If you did a Complete System install (both FMU Console and Server on the

same computer), use the following steps to set up FMU.

1. Open

FMU Console by choosing it from the Start menu.

2. A Default Group is created automatically for you during installation.

If you want to assign terminals to a group other than the Default

Group, create the group(s) to which you want to add the terminals

before proceeding (see “Adding a Group” on page 29).

3. Set up terminals to communicate with FMU (see “Enabling a Termi-

nal for FMU with Direct Connect” on page 50 and “Enabling Termi-

nals for RF Connectivity” on page 52).

Separate Workstation/Server

If you have installed FMU Console on one computer and the FMU Server

software on one or more other computers, use the following procedures:

1. Open

FMU Console by choosing it from the Start menu.

2. Add a server (see “Adding a Server” on page 26).

3. A Default Group is created automatically for you when a server is

added. To assign terminals to a group other than the Default Group,

create the group(s) to which you want to add the terminals before

proceeding (see “Adding a Group” on page 29).

4. Set up terminals to communicate with FMU (see “Enabling Termi-

nals for RF Connectivity” on page 52).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Sem comentários

Datalogic-scanning PDA Manual do Utilizador Página 20